8
EN
• Do not coil the power cable around or on top of the product while it is working.
• If the cable gets damaged it must be replaced by S&P – take the equipment to our offi cial S&P
because the work must be done by specialist personnel to avoid any risk of damage.
• The heater must always work vertically, with the controls at the top and the base located on a
stable surface.
• Only for internal use.
• Do not use this heater in the immediate vicinity of a bathtub, shower or swimming pool.
• Do not use this heater if it has been dropped.
• Do not use if there are visible signs of damage to the heater.
• Use this heating appliance on a horizontal and stable surface, or if possible fi x it to a wall.
•
WARNING:
Do not use this heater in rooms that are occupied by persons who cannot leave the
room by themselves, unless permanent surveillance is provided.
•
WARNING:
To reduce the risk of fi re, keep textiles, curtains, or other fl ammable material at
least 1m away from the air outlet.
2. THE PRODUCT
Description of the product
(Figure 1
):
A Outlet
air
B Thermostat
C Power
selector
D LED
E Transport
handle
F Inlet
air
G Safety tilt switch
3. USE AND OPERATION
• Before connecting the product to the power, make sure that it is located on a stable fl oor and has a fi rm vertical position.
Remember that as a safety feature, the product incorporates a safety tilt switch under the base
(Fig.1 G)
• Connect the plug into the power point. The heater is a Class II appliance and it does not require an earth connection.
• Select the required power using the power selector and move the thermostat control to maximum position.
− Power selector (Fig.1C).
O
Stop
Fan (cold air)
I
Hot air heater (800W)
II
Very hot air heater (1800W)
− Thermostat (Fig.1B)
Min.
Max.
Once the room has reached the desired temperature, slowly move the control until there is a soft “click” and the device
is disconnected. From this time the heater turns on and off automatically, keeping the pre-selected comfort tempera-
ture.
Note: The LED is illuminated whenever the heater is operating.
• Anti frost device
This device is especially useful in places where low temperatures are reached and there is a risk of water freezing in
internal water pipes. The heater will automatically maintain the temperature of the room at about +5ºC when left on this
setting.
