©
Copyright 2014, Sargent & Greenleaf
Page 8
d
ual
u
ser
m
ode
F
unctIon
— c
hange
k
ey
r
equIred
Dual user mode requires two different combinations to open the lock. After the first combination is entered, the second combination must be
entered within two minutes to accomplish an opening. Here is the process to change the 2740B from single user mode to dual user mode:
1. Open the lock using the existing single user combination.
2. With the safe or container open, extend the lock bolt fully.
3. Wait ten seconds, then insert the change key into the receptacle in the lock cover.
4. Turn the dial right (clockwise). As you turn, the lock will sound one short beep. Continue to turn the dial right at least two times to 20.
5. Turn the dial left (counterclockwise). As you begin to turn the dial, the lock will sound three quick beeps. Continue dialing left at
least two revolutions, then stop when the first number of the existing single user combination comes to the index.
6. Turn the dial right (clockwise) until the second number of the existing single user combination comes to the index.
7. Turn the dial left until the third number of the existing single user combination comes to the index. Then turn the dial right until you
hear three quick beeps from the lock.
8. Turn the dial left (counterclockwise) at least two complete revolutions. Now stop when the first number of the NEW user #1
combination comes to the index.
9. Turn the dial right (clockwise) until the second number of the NEW user #1 combination comes to the index.
10. Turn the dial left until the third number of the NEW user #1 combination comes to the index. Then turn the dial right until you hear
three quick beeps from the lock.
11. Turn the dial left (counterclockwise) at least two full revolutions, then stop when the first number of the NEW user #2 combination
comes to the index.
12. Turn the dial right (clockwise) until the second number of the NEW user #2 combination comes to the index.
13. Turn the dial left until the third number of the NEW user #2 combination comes to the index. The lock will sound two quick beeps.
14. Enter the two new dual user combinations one more time, following steps 8 through 13.
When you complete step 13 again, turn the dial right (clockwise) and instead of hearing the two quick beeps, five quick beeps will
sound to indicate a successful combination change. Continue turning the dial right to retract the lock bolt.
15. Remove the change key from the lock.
Do not close the safe door or container drawer until you have checked the new combinations for proper operation at least
three times with the door or drawer OPEN. If necessary, refer to page 3 for dual user operating instructions.
O
perating
i
nstructiOns
S&G
™
Model 2740B
Electromechanical Safe Lock
