19
4.1.2 Transmitting Power
Transmitting power ser is to be used setting strong(600W) or weak(300W).
4.1.3 Pulse Width
The pulse width set is to be used for setting its long or short.
4.1.4 Depth
This is to adjust an error occurred by transducer’s installation position. Due to the transducer is installed
at the bottom of vessel, It should be a little lever error between water surface and the transducer.
Thus distance from water surface to transducer needs to be adjusted for measurement correctly.
The range of correction is 0~99m. When you adjust it then using direction key “[
◀
],[
▶
]” can change
increasing/decreasing by 10, “[
▼
],[
▲
]” can change increasing/decreasing by 1.
Example
Example
Example
Example
Select [Transmitting Power]
Select [Transmitting Power]
Select [Transmitting Power]
Select [Transmitting Power]
Select [Depth]
Select [Depth]
Select [Depth]
Select [Depth]
Example
Example
Example
Example
Example
Example
Example
Example
Select [Pulse Width]
Select [Pulse Width]
Select [Pulse Width]
Select [Pulse Width]
Summary of Contents for SES2000
