51
5.6.6 Tune ADJ
On the front, there is key control knob for Tunning and may be adjusted by 64
different levels.
For setting procudre, make Tune VR to the center and set target object and
Tune knob to the maximum.
5.6.7 MT-RPM ADJ
This is how to set for the Antenna s motor RPM.
Motor rotartion will display with RPM measurement, normal operatiing rotate
per minute is 24 RPM.
ATTENTION) When you operating in high speed then targeting object accuracy
will decrease and system speed may be decrease.
5.6.8 Software Upgrade
This menu will upgrade previouse software program.
5.6.8.1 Stc Curve Min
STC Curve
②e③③ing
s minimum value is as 1~255
5.6.9 Default manufacturing Setting
This menu will reset the default manufacturing settings.
ATTENTION) This menu is limited to use by end-users.
5.6.10 Default basic manufactreing set-up
This menu will reset devise to basic set up from the manufacuter.
52
!
ATTENTION
Device came out with fully adjusted. For resetting for default basic
manufacture is limited to end-users. Not recomannding for adjusted by
end-users all the time.
