Samuel Strapping Systems P-625, Safety, Operation, Maintenance And Parts Manual, Page: 22 / 54

22
MAINTENANCE
GENERAL. Periodic checks of all drive belts for
replacement should be made to prevent worn
out or stretched belts, which will affect
tensioning.
TENSION TRIP ARM ASSEMBLY SLEEVE.
Apply a few drops of light machine oil to the
edge of the sleeve so that the oil can penetrate
to the shoulder of the screw.
TOP SLIDE, GUIDE PLATES, WELDING
CLAMP, END GRIPPER, AND HOLDING
GRIPPER. Apply light machine oil to these
parts at the point indicated in figure 27
LUBRICATION. Make sure the machine is
clean before applying lubricants to the points
shown in Figure 27. Note: use a brush or
compressed air to remove any dirt or debris.
GEAR REDUCER. Replace the oil in the gear
reducer once a year in the following manner:
1. Remove the OIL FILL plug at the top of the
reducer.
2. Remove the lower plug and allow the oil to
drain from the gear housing.
3. Reinstall the lower plug and fill with gear oil.
4. Reinstall the upper plug.
Note: The following parts should NEVER be
lubricated:
1. Electromagnetic
clutch
2. Roller assemblies
3. Belts and pulleys
4. Clutch
discs.