background image

Install the angle adjustment bracket on the wall as shown in the
figure.

Wall Bracket Assembly

Securely fix the set to the wall. Pull the bracket forward and unfold it. Insert
the bracket to the assigned area of the angle adjustment bracket and tighten
the supplied 8 screws . (Same for both left and right side)

Tighten the angle adjustment bracket by using anchors and screws
orderly from 

to  .

If it cannot be installed on the assigned area, install at the nearest
place.

Remove the screws on the LED set. Put the plastic hanger and 4 screws

together

and firmly tighten on the back panel.

W

W

a

a

r

r

n

n

i

i

n

n

g

g

1. Mount the product on the wall bracket. Be sure to check on the left and right side to see if it is properly fixed.

2. Be careful when installing the product or adjusting the angle as fingers can be caught in the holes.

3. Be sure the wall bracket is securely fixed to the wall. Falling down the product may cause physical dama

Make a hole in the wall with the drill of
6x50.

How to Tighten Anchors or Screws

Clean up the hole.

Insert the supplied anchor to the hole.

Match the angle adjustment bracket to
the holes on the wall and tighten the
screws .

Use the drill with the required size when making a hole in the wall.

Be sure to follow the directions for the installation to avoid safety
problems.

W

W

a

a

r

r

n

n

i

i

n

n

g

g

1. Check the solidity of the wall before the installation. Strengthen the wall and install the bracket if the wall is not firm enough.

2. The supplied screws and anchors are for installing on concrete walls.

3. For the wall of plaster, marble, or steel, use the appropriate screws.

Slim, Normal LED

Ultra-Slim Only

Summary of Contents for WMN-4270SD









Reviews: