28 _ Troubleshooting
Error Type
Drum
Fully
automatic
Causes
Remarks
Error
mode
Old
error
mode
For USA
Water Leakage
Error
LE
LE1
11E
E9
LE
LE
- Heater engagement fault (out of place)
- The air hose is out of place and water leakage
occurs during the spin cycle.
- The tube back near the bolt fixing part is broken.
- Water leakage occurs at the front with foaming
because of too much detergent
- Water leakage occurs because the connecting
hose to the detergent drawer is connected
incorrectly.
- The drain pump filter cover is engaged incorrectly.
- Water leakage occurs at the drain hose.
- The duct condensing holding screws are worn.
- The nozzle-diaphragm is engaged in the opposite
direction or the rubber packaging is omitted.
- Water leakage occurs because the screws that
hold the tub back and front in place are fastened
incorrectly.
- The leakage sensor is faulty.
Overflow Error
OE
OF
OE
OF
E3
OE
-
- Water is supplied continually because the water
level detection does not work.
- Because the drain hose is clogged and there
is an injection error (at a narrow section), the
water level detection does not work and water is
supplied continually.
- Water is supplied continually because of freezing
or because there is foreign material in the water
supply valve.
- This error may occur when the water level sensor
is degraded.
For USA
products, this
error occurs
because the
water level
sensor terminal
is out of place.
Temperature
Sensor Error
tE1
tE1
6E
tE
-
- The washing heater in the tub has an error.
(Contact error, temperature sensor fault)
- The connector is connected incorrectly or is
disconnected.
- If the water level sensor operates without water
because the water is frozen or for any other
reason and the temperature sensor engaged at
the bottom to prevent overheating of the washing,
then the sensor detects a temperature of 100-
150°C then the washing machine turns the input
power off.
Heater sensor
fault
: When the
connector is
connected
incorrectly or
has a wire
disconnected
or contact error
tE2
tE2
-
-
- The temperature sensor for the duct assy fan
housing is faulty.
(A sensor fault such as an internal short-circuit or
wire disconnection)
- The connector is out of place or has a contact
error.
Duct
condensing
temperature
sensor fault (for
models before
the silver nano
function was
applied)
tE3
tE3
-
-
- This occurs when the duct condensing
temperature sensor is open.
- This occurs when the duct condensing
temperature sensor has a wire disconnected or is
short-circuited.
- The connector is out of place or has a contact
error.
Dry heater
temperature
sensor fault (for
models before
the silver nano
function was
applied)
Unbalance
Error
UE
UE
E4
dc
UE
- As laundry causes this error, check the laundry.
- Find the reason for the unbalance and solve it as
directed in the user manual.
