20_
setting up your new washing machine
Connecting the drain hose
The end of the drain hose can be positioned in three ways:
1.
Over the edge of a wash basin:
The drain hose must be placed at a height of between 60
and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure
the guide to the wall with a hook or to the tap with a piece of string to prevent the drain hose
from moving.
2.
ln a sink drain pipe branch:
The drain pipe branch must be above the sink siphon so that
the end of the hose is at least 60 cm above the ground.
3.
ln a drain pipe:
We recommend using a 65 cm high vertical pipe; it must be no shorter than
60 cm and no longer than 90 cm.
The standpipe drain requires;
• minimum diameter 5 cm.
• minimum carry-away capacity 60 liter per minute.
sTEp 5
powering your washing machine
Plug the power cord into a wall sockets, an AC 220-240V / 50Hz approved electrical outlet
protected by a fuse or circuit breaker. (For more information on electrical and grounding
requirements, see page 14.)
test run
Make sure that you install your washing machine correctly by running the
Rinse+spin
cycle
after the installation is complete.
sTEp 6
Calibration mode
Samsung washing machine detects the laundry weight automatically. For more accurate
weight detection, please run Calibration Mode after the installation. Calibration mode is done by
following the steps below.
1.
Remove laundry or any contents in the machine and turn off the machine.
2.
Press the
Temp
button and
delay End
button simultaneously, and press the
power
button
in addition. Then the machine turns on.
3.
Press the
start
button to activate “Calibration Mode”.
4.
The drum rotates clockwise and counterclockwise approximately for 3 minutes.
5.
When “Calibration Mode” is finished, “End(En)” appears on the display, and the machine
automatically turns off. The washing machine is now ready for use.
setting up your washing machine
Drain hose
Hose guide
60 ~ 90 cm
60 ~ 90 cm
WF1804WP-03025Q-03_EN.indd 20
2014/6/30 13:50:36
