Disassembly and Reassembly_29
Part name
Description
Figure
DD
MOTOR
1.Unfasten the 4 screws that hold
the back cover in place. Remove
the back cover by sliding it down.
2. After removing the back cover,
unfasten the M19 nut that holds
the motor in place.
Do not try to unfasten the nut
by inserting a screw driver into the
motor. This may cause a motor
malfunction.
3. Remove the M19 nut washer and
then remove the rotor.
4. Unfasten the six (6) M10 screws.
Remove the assy bracket motor.
Remove the stator.
5. Remove the motor wire and hall
sensor while holding down the
navel of the housing.
√
Check Points for Troubleshooting
1. Check whether there are any foreign substances between the rotor and
the stator.
2. Check whether the motor power wires (blue, while, red) are connected
correctly.
3. Check whether the hall sensor wire is connected correctly.
- Connect the motor power wires in the order blue, white and red, starting
from the furthest right. Check whether each voltage between blue and
white, white and red, red and blue is 15Ω.
MoToR WIRE
HALL SENSoR
WD6500K_7-8-9-11kg_1400rpm-SM.indb 29
2018/11/9 9:53:26