12_
Troubleshooting
HOW TO ADD THe FAbRIC SOFTeNeR
Slide and open the cover in the direction of the arrow, insert the rinse detergent, and slide and close it
in the reverse direction.
• When a proper amount (one time does) of fabric softener is stored in the softener inlet,
it is automatically put in at the last rinsing cycle.
• Do not use detergent, bleach or starch into the Softener Inlet.
• Using too much softener may produce unsatisfactory results.
• Do not open the lid during the Spin Dry cycle. If added too early, its effectiveness will decrease.
• Do not leave the softener into the Softener Dispenser for a long time. Because softner became stiff.
WATeR SUppLy CONNeCTOR FILTeR
1.
Pull out the filter and wash well.
2.
Pull in the filter and connect the hose to the inlet water valve tightly.
3.
Check if there is a leakage. Note to tighten up the connector.
CLeANING THe FILTeR
1.
Push the upper part of the Magic filter and pull in.
2.
Open the cover as shown in the figure.
3.
Clean the Magic filter.
4.
Close the cover and insert the lower part of the filter in the basket first and
then push the filter with “click” sound.
HOW TO CLeAN THe pUMp FILTeR (OpTION)
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate the filter clockwise until it locks in position.
installation & maintenance
FILTER
OPEN CLOSE
RAG
REAR SIDE
WA95W9-02898M-01_EN.indd 12
2012-12-18 �� 5:08:55
