Troubleshooting
_11
ASSeMbLING THe RAT pROTeCTION pANeL (OpTION)
Tilt the washer a little and lift up the panel until it
clicks, finally fix the panel with screw to the base
as shown in the figure.
1.
Insert the rat protection panel to the
assembling hole on back side to
the end.
2.
If you have difficulty inserting the
panel lift up the washer a little and
insert it.
HOW TO CONNeCT THe DRAIN HOSe
in cAse of pump-DrAineD WAsher (opTion)
Take out the cap-hose and connect the outlet-hose.
cap-hose
Be sure to join tightly the drain hose into the drainoutlet on the back of the
machine.
Be sure to join tightly the drain hose into the drain-outlet on the side of the
machine.
Install the drain hose in the position of about 90~100cm above the ground.
90~100cm
connecTing The DrAin hose
After pressing the joint ring(a), insert the drain hose(b) to drain
direction.
Test run
Make sure that you install your washing machine correctly by running the
rinse
+
spin
cycle after the
installation is complete.
HOW TO pUT THe DeTeRGeNT IN
1.
Open the detergent box by pulling in the direction of the arrow as shown in the figure and then
put the powder detergent in the detergent box.
2.
Put in one-time amount of detergent evenly so the detergent may not brim over the box.
If you spread a powder detergent over the laundry directly, it may result in discoloration.
Make sure to insert it into the detergent compartment.
cAuTion
(a)
(b)
Rear-side
WA95W9-02898M-01_EN.indd 11
2012-12-18 �� 5:08:54
