4. Pull down the filter net.
ASSEMBLING THE RAT PROTECTION PANEL
Tilt the washer a little and lift up the panel until it clicks,
finally fix the panel with screw to the base as shown
in the figure.
1.Insert the sound
absorbing panel
to the assembling
hole on back side
to the end.
2.If you have difficulty
inserting the panel,
lift up the washer a
little and insert it
HOW TO PUT THE DETERGENT IN
1 .Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim over the box.
Detergent Device
Put the detergent
in proportion to
water level
Softener Device
Softener
baseline
CAUTION:
If softener is stored over the above base line, it may flow down at any time.
WATER SUPPLY CONNECTOR FILTER
1.Pull out the filter and wash it well.
inlet water
valve
2. Pull in the filter and connect
the hose to the inlet water
valve tightly.
3. Check if there is a leakage.
Note to tighten up the
connector.
CLEANING THE FILTER NET
Clean the filter net often to keep the washer clean.
1. Push up and
pull out the filter net.
2. Remove the collected
lint from the filter net.
3. Clean the filter.
8
