English
27
Installation
STEP 5
Power on
Plug the power cord into an AC 120 V / 60 Hz / 15 AMP approved electrical outlet
protected by a 15-amp fuse or circuit breaker. Then, press
Power
to turn on the washer.
STEP 6
Run a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1.
Load about 6 lb. of laundry into the tub.
2.
Press
Power
to turn on your washer.
3.
Turn the
Cycle Selector
to
RINSE+SPIN
.
4.
Press and hold
Start/Pause (Hold to Start)
to start the test cycle.
5.
The washer should not rock or vibrate excessively when water is supplied or when
washing and spinning, and should drain well during the spin cycle.
NOTE
• If water leaks while water is being supplied or drained, check the water connections.
See “
• If the washer rocks and vibrates excessively, level your washer again. See “
.
Untitled-25 27
2020-03-02 PM 2:15:48
Summary of Contents for WA50R5200AW/US
