28_
troubleshooting and information codes
28_
troubleshooting and information codes
troubleshooting and
information codes
CHECK THESE POINTS IF YOUR WASHER...
PROBLEM
CHECK & SOLUTION
Has no power.
Check if the electric voltage is normal.
Check if the washer is plugged in. Make sure the electric cord is
plugged in.
Make sure that the drain hose is not twisted or folded.
Make sure that the drain hose outlet is not clogged.
Does Not Work
Is the washer lid open?
Â
Close the lid.
Is the Hold button on?
Â
Press the Start/Pause button again, and check if the washer
starts.
Has suffi cient water fi lled up to the water level?
Â
If the water pressure is low, it takes along time for water to fi ll
the washer.
Is the faucet closed?
Â
Open the faucet to supply water.
Has the drain hose and spin basket
frozen.
Add hot water to the frozen water tap and remove the drain
hose. Soak it in hot water.
Pour hot water into the spin basket for about 10 minutes.
Place a hot water towel on the drain hose connector.
When the drain hose has been defrosted, reconnect it and
check if the water is draining properly.
The water leaks at the water supply
hose connector.
If the faucet connecting part is loose, water may leak.
Â
Repeat the assembling steps again. (Refer to “Connecting the
water supply hose”)
Check if the rubber ring of the water supply hose is in the right
position.
Â
Fit it tightly again.
Is the water supply hose folded?
Â
Unfold the hose.
If the water supply is too strong, water may leak.
Â
Close the faucet a little.
Is water leaking from the faucet itself?
Â
Fix the faucet. Water is not supplied.
Did you press the Start/Pause button after selecting the water
supply?
Â
The Start/Pause button must be pressed for water, for water
to be supplied. Press the Start/Pause button.
WA17GWGIH-02685M_EN.indd Sec5:28
WA17GWGIH-02685M_EN.indd Sec5:28
2011-12-06 3:39:32
2011-12-06 3:39:32
