Samsung WA1635D0DW/XAP, Service Manual

Page: 8 / 36

2.SOAK COURSE
(1) The soak course is performed only when it is selected by using manual key.
(2) If the water is supplied up to the selected water level, soaking is repeatedly performed by 5 min.interval for
total 30 min. (Motor rotates for 1 min. and stops for 4 min.)
(3) If the water level is changed to a higher level while soaking is in operation, it stops soaking and starts water
supply, and then resume the soaking process(for all course and water level).
(4) Once the soaking is stopped and resumed again for any reason such as changed water level or Pause and
Re-start, the ongoing settings are still valid starting the soaking process from the breakpoint.
3.WASH FUNCTION
(1) Water Plus is performed if the current water falls short of the selected water level by sensing the water level
setting, washing for 2 min and 9 min, turning the Motor OFF for 3 sec., then reading the water level
frequency, and the washing process goes on after proper water supply. The time for Water Plus does not
exceed Max. 30 seconds (for all course and water level).
* In case of rinse, economy wash and wool course, water plus is performed 1 min. later.
(2) Though the washing time is changed during in washing operation after performing the water plus function, it
does not perform the function anymore. Water plus is not performed when the water plus setting time has
passed.
2-3-2 RINSE PROCESS
1. DRAIN FUNCTION
(1) Drain function maintains the drain valve open ON.
If the water level at initial operation is higher than Reset, the drain function is performed for 50 seconds after
detecting Reset. If the water level at initial operation is lower than Reset, the drain function is performed for
20 seconds after detecting Reset.
(2) After starting the drain function, the remaining time starts counting down until the standard drain time
elapses, and stops counting down thereafter. If the drain function is completed, it is regarded as the
standard drain time is finished.
(3) If the water level is still higher than Reset when 5 min has passed after drain function is started, it performs
Drain Error function. Buzzer beeps 5 times and then enters the Pause mode.
(4) If the Start key is pressed in the above item (3), the Error status is cleared and Time Out is reset to 15min
again and then drain function resumes.
2.INTERMITTENT SPINNING
1) Opening the door while the Intermittent Spin is in operation stops spinning and generates Door Open Alarm
(Door Open Melody 5 times).
2) If the door is closed while the Door Open Alarm is ongoing, the alarm status is terminated and proceeds to
the next step in as identical order as in Start/Pause key-in.
3) If the Satefy S/W is sensed as Unbalance during the Intermittent Spinning cycle, it performs Unbalance Clear
function.
1. Unbalance Sensing Function
- S/W Sensing Time
UNBALANCE : 20~449mS, Door Open : 450mS or more.
If the Door is closed while the Door Open Alarm is undergoing, the alarm status becomes invalid and the
drain valve turns ON min. 10 seconds after OFF, and MOTOR resumes 10 seconds after the drain valve
turns ON.
Water Level High Middle Low Extra Low Lowest Remark
Drain Time 2 min.10 sec 2 min. 1 min.50 sec 1 min.40 sec 1 min.30 sec 50 sec DELAY excluded