Samsung WA1635D0DW/XAP, Service Manual

Page: 12 / 36

2-5 TEST PROGRAM MODE
2-5-1 TEST MODE FUNCTION (Drive and other test)
1) How to enter: (Water level + Power s/w)
2) MODEL change: you may change mode by pressing COURSE key in test mode.
3) Mode discription
MODE NO. DISPLAY TEST CONTENT REMARKS
1 "01"
AGING TEST FOR DRIVING Drive and Display turn ON/OFF
as follows. SPIN LAMP (DRAIN/MOTOR) Cold water. Hot water
SPIN LAMP (RINSE) "r" 7-SEG (MOTOR RIGHT) "L"
Open and close
door, and you
may run
dehydration after
UNB.
2 "02"
SPIN AGING MODE
After detecting reset in 50 sec. it proceeds starting intermittent
spin in 3rd times and then continues spin course in the order
of 5 min. ON and 3 min. OFF.
If the initial water level is under reset it starts intermittent spin
after 20 sec.
- Door error or unbalance error will be detected and displayed
as follows.
Door error : "dE" UNBALANCE ERROR : "UE"
3 "03"
It is selected under the condition of high water level set (Hot
water/Cold water) and motor starts rotating repeatedly after
supplying high water level.
4 "04"
Water level sensor is marked by HEX-DECIMAL VALUE in
water level frequency.
5 "05"
Weight sensor is marked by HEX-DECIMAL VALUE as
med.low, extra low when pressing the water level key.
6 "06"
Weight sensing test/value indicate mode Start key-in performs
weight sensing and total pulse number displays after selecting
water level. It is marked on the 7-SEGMENT under 100, SPIN
LAMP turns ON over 100 and RINSE AND SPIN LAMP turn
ON over 200.
7 "07"
TEST MODE OF WATER SUPPLY VALUE cold water for
RINSE VALUE turns ON/OFF by 2 sec. REPEATED MODE
8
"08"
"OE"
Med. low, extra low A/D PORT OPEN/SHORT PIN NO DISPLAY
OVER FLOW ERROR FUNCTION
It performs the release function during in operation which
drains overflow water level to selected water level by 2 times
and performs overflow error function in 3rd times when over
error happens keeping motor going on until power OFF