installation & maintenance_17
CAUTIONS WHEN INSERTING THE DRAIN HOSE
Less than 3 m
1.
Don’t exceed more than 3 m when the
drain hose is used by connecting with
other hoses.
2.
Be careful to drain water out at the end of
the drain hose.
Less than 3 m
Less than
5 cm
3.
The doorsill shoudn’t be more than 5cm.
4.
Don’t install the drain hose underneath the
wash machine.
Test run
Make sure that you install your washing machine correctly by running the
Rinse
+
Spin
cycle
after the installation is complete.
ADDING DETERGENT
1.
Open the detergent drawer and then add the powder
detergent into the detergent compartment.
2.
Add detergent evenly so that it doesn’t brim over the
edge of the drawer.
•
Use a reasonable amount of detergent.
If you use more detergent than the standard
quantity or the water temperature is too low and the
detergent does not dissolve in the water completely
causing it to remain on the laundry and in the hose and tub, it may cause damage such
as dirtying and discoloring the laundry.
•
If you use a powder detergent and it remains on the laundry, it may cause a bad odor.
Rinse the laundry suffi ciently in fresh water.
If you spread a powder detergent over the laundry directly, it may result in discoloration.
Make sure to insert it into the detergent compartment.
If the water pressure is low, the detergent may remain in the detergent compartment.
ADDING FABRIC SOFTENER
1.
When the proper amount (one time dose) of fabric softener is stored in the softener inlet, it is
automatically added during the last rinse cycle.
2.
Do not add detergent, bleach or starch into the softener inlet.
3.
Using too much softener may produce unsatisfactory results.
4.
Do not open the lid during the Spin cycle. If added too early, its effectiveness will decrease.
5.
Do not leave the softener in the softener dispenser for a long time as it may congeal.
If the water pressure is low, the fabric softener may remain in the softener compartment. In
this case, put the fabric softener into the tub directly.
CAUTION
03 INST
ALLA
TION & MAINTENANCE
F500-03273C-03_EN.indd Sec6:17
F500-03273C-03_EN.indd Sec6:17
2/21/2017 4:48:06 PM
2/21/2017 4:48:06 PM