Samsung VP-D451, Service Manual

Page: 117 / 184

Operating Instructions
Samsung Electronics 11-3
ENGLISH
Preparation
22 22
Table of continuous Recording Time based on Model and Battery Type.
✤ If you close the LCD screen, it switches off and the Viewfinder switches on automatically.
✤ The continuous recording time given in the table below are approximations.
Actual recording time depends on usage.
[ Notes ]
■ The Battery pack should be recharged in an environment between 32 °F (0 °C) and 104 °F (40 °C).
■ The Battery pack should never be charged in a room with a temperature below 32 °F (0 °C).
■ The life and capacity of the Battery pack will be reduced if it is used in temperatures below 32 °F (0 °C) or left in temperatures
above 104 °F (40 °C) for a long period of time, even when it is fully recharged.
■
Do not put the Battery pack near any heat source (i.e. fire or a heater).
■ Do not disassemble, apply pressure to or heat the Battery pack.
■
Do not allow the + and – terminals of the Battery pack to be short-circuited.
Doing so may cause leakage, overheating, or fire.
■ Use SB-LSM80 or SB-LSM160 Battery pack only.
■ Be sure to use a recommended battery pack as described above. The batteries are available at a SAMSUNG retailer.
Battery
SB-LSM80
SB-LSM160
Charging
time
Approx.
1hr 20min
Approx.
3hr
LCD ON VIEWFINDER ON
Continuous recording time Time
Approx.
1hr 20min
Approx.
2hr 40min
Approx.
1hr 30min
Approx.
3hr
ENGLISH
Preparation
21 21
Using the Lithium Ion Battery Pack
✤ The amount of continuous recording time available depends on.
-
The type and capacity of the Battery pack you are using.
- How often the zoom function is used.
It is recommended that you have several batteries available.
1. Attach the Battery pack to the Camcorder.
2. Connect the AC Power adapter to an AC Cord and connect the AC Cord to
a wall socket.
3. Connect the DC cable to the DC jack socket on the Camcorder.
4. Turn the
Power switch to OFF , and the charging indicator will start to flash,
showing that the battery is charging.
5. When the battery is fully charged, disconnect the Battery pack and the AC Power adapter from
the Camcorder.
Even with the
Power switched OFF , the Battery pack will still discharge.
[ Notes ]
■ The Battery may contain a slight charge at the time of purchase.
■
To prevent reduction in the life and capacity of the Battery pack, always remove it from the Camcorder after it is fully charged.
■
The amount of continuous recording time available depends on:
-
The type and capacity of the Battery pack you are using.
- How often the zoom is used.
- Type of use (Camcorder/Camera/With LCD screen etc.).
- Ambient temperature.
It is recommended to have additional battery packs available.
■ Even when the Power switched Off, the Battery pack will still discharge if it is left attached to the device.
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50% ~ 75%
Three times per second 75% ~ 90%
Blinking stops and stays on 90% ~ 100%
On for a second and Error - Reset the Battery pack and
off for a second the DC cable
Power Switch
Charging the Lithium Ion Battery Pack
4
<Charging indicator>