Samsung VP-A12, Service Manual

Page: 42 / 163

Alignment and adjustment
Samsung Electronics 5-3
This remote control(accessory unit) is used to control the camcorder additionally, card remote control
(Parts No. AD59-10379A) should be used for adjustment of the camera section.
START
/STOP
REW
DISPLAY
SELF TIMER STOP
F.F
PLAY
STILL
CONFIRM
MODE
DOWN
MODE
UP
DATA UP
DATA
DOWN
FAR
NEAR
Remote for camcorder
Adjust for jig (Part No. : AD59-10379A)
Figure of button placement when remote is
used for service adjustment.
Reassignment
in the
adjustment mode
Note : In service adjustment mode, button names are different from those in customer camera function control
mode. EX) Start/stop button is the same as confirm.
5. How to get into service Ò ADJUST Ó mode
1. Remove the lithium battery from the
camcorder.
2. Connect the power source (battery/
DC cable).
3. Eject the tape if it is in the unit.
4. Set the power switch of the
camcorder to ÒCAMERAÓ position.
5. Set OSD on state.
STEP 1
1. Press and hold ÒDATEÓ button on camcorder for
more than 3 seconds, then it goes into ÒCLOCK
SETÓ mode. One of the digits will blink.
2. PRESS ÒSTILLÓ Button 4 times on the camcorder
so blinks Ò00Ó on the screen.
3. Rotate the DSE dial on the camcorder
until ÒNEGAÓ shows on the screen.
4. Press and hold the ÒC/RESETÓ button and
ÒREWÓ button on the camcorder at the same time
for more than 3 seconds. Then unit goes into
service mode. ÒADJUST?Ó blinks on the screen.
This indicates that you are ready to adjust any
electronic variable resistors.
STEP 2
ÒADJUST ?Ó will now be blinking at the center of
screen. Now press ÒSTART/STOPÓ button of the
remote control.
STEP 3
On screen display show “E2 HALLA XX XX”
CAMERA ADJUSTMENT mode has successfully
been activated.
12 :Ò00Ó: AM
1.JAN.1997
OSD
Note : When ÒXX XXÓ is shown in service adjustment precedures, this indicates variable values.