Samsung Electronics
18
Set Up the Model Option
7
8
Press button, then the default value is .
Push the button to set the display panel to
.
Every time you push the button, the display panel reads
. . .
repeatedly.
10
Push the button to set the display panel to
.
Every time you push the button, the display panel reads
. . .
repeatedly.
9
Push the button to set the display panel to
.
Every time you push the button, the display panel reads
. . .
repeatedly.
11
Push the button to set the display panel to
.
Every time you push the button, the display panel reads
. . .
repeatedly.
12
Push the button to set the display panel to
.
Every time you push the button, the display panel reads
. . .
repeatedly.
9
8
7
10
11
12
✳
Setting is not required if you must
a value which has a
default.
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key, to set the display part to
and check the display part.
The display part shows .
Press the Mode Selection key, to set the display part to
and check the display part.
The display part shows .
Step 4 : Pressing the ON/OFF button (
)
When pressing the operation ON/OFF key with the direction of remote controller for unit, the sound ''Ding'' or “Diriring” is
heard and the OPERATION ICON(
) lamp of the display is flickering at the same time, then the input of option is com-
pleted. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote controller.
Second, Re-insert the battery into the remote controller.
Third, Press ON/OFF key with the direction of remote controller for set.
• Error Mode
1
st
If all lamps of indoor unit are flickering, plug out, plug in power plug again and press the ON/OFF key to retry.
2
nd
If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code is
set up for its model.
DB98_16202A(4)_1 04/3/29 12:20 PM Page 18
