English - 38
Configuring Network Connections
After you have run the initial setup, you can configure or reconfigure the network connections through the
TV's menu.
Configuring a Wireless Network Connection
The instructions below are for networks that use the Dynamic Host Configuration Protocol (DHCP) to
configure network connections automatically. Most wireless networks use DHCP. If you have a Static IP
network, see the e-Manual for configuration instructions.
To configure the network connection for a network that uses DHCP, follow these steps:
1.
Connect your TV to your network as shown in the illustration on page 36.
2.
Turn on your TV, and then go to the
Network Settings
screen. (
Menu
→
Network
→
Network
Settings
)
3.
Select
Start
. The Network function searches for available wireless networks. When done, it displays a
list of the available networks.
4.
In the list of networks, move the highlight to select a network, and then select
Next
.
✎
If you have a WPS(PBC) compatible router, select
WPS(PBC)
instead, and then follow the
directions on the screen.
5.
Enter your network security key or WPS PIN using your remote.
✎
Enter numbers and letters using your remote.
•
If you are using the standard remote, you can enter numbers by pressing the number buttons
on your remote.
•
To enter a letter, move the Highlight to the letter, and then select it. You can enter numbers in
the same fashion if you choose.
✎
To display capital letters (or redisplay small letters if capital letters are displayed), select
Caps
or
Shift
.
✎
To display symbols and punctuation, select 1
F
. To redisplay letters, select 1
F
again.
6.
When done, select
Next
if you have entered a security key or
WPS PIN
if you have entered a WPS PIN.
7.
The TV checks the wireless connection. If the connection is successful, the “
You are connected to the
Internet. If you have any problems using online services, please contact your Internet Service
Provider.
” message appears. Select
Next
using your remote.
✎
For more detailed information, see “Setting up the Wireless Network” in the e-Manual.
✎
If you want to configure the connection manually, select
IP Settings
on the Network Connection
screen. Set
IP Setting
to
Enter manually
, and then enter the
IP Address
,
Subnet Mask
,
Gateway
, and
DNS Server
manually.
[UE7550-ZA]BN68-04371A-00Eng.indb 38
2012-05-31 �� 4:58:02
