Samsung SyncMaster P2770HD, Service Manual

Page: 33 / 65

4-18
4. Troubleshooting
4-9-3 White Balance - Adjustment
3. W/B
(low light) (hight light)
Sub Bright
R offset
G offset
B offset Sub Contrast
R gain
G gain
B gain
(W/B adjustment Condition refer next page)
4-10. White Ratio (Balance) Adjustment
You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance). 1.
Since the adjustment value and the data value vary depending on the input source, you have to 2.
adjust these in Component and HDMI modes.
The optimal values for each mode are configured by default. (Refer to Table 1, 2) 3.
It varies with Panel’s size and Specification.
- Equipment : CA210
- Pattern: MIK K-7256 #92 “Flat W/B Pattern” as standard
- Use other equipment only after comparing the result with
that of the Master equipment.
- Set Aging time : 60min
- Calibration and Manual setting for WB adjustment.
HDMI : Calibration at #24 Chessboard Pattern Manual adjustment #92 pattern (720p)
COMP: Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (720p)
- If finishing in HDMI mode, adjustment coordinate is almost same in COMP mode.
- White Balance Manual Adjustment