4
INSTALLATION & MAINTENANCE
1.Remove the adaptor from the
water supply hose.
2.First,using a "+" type screw
driver, loosen the four screws
on the adaptor.
Next,take the adaptor and
turn part(b) following the
arrow for gap about 5mm
between them.
3. Connect adaptor to the water
tap by tightening the screws
firmly.
Then,turn part (b) following
the arrow and put (a) and
(b)together.
5.Connect the other end of the
water supply hose to the inlet
water valve at the top of the
washer.
Screw the hose clockwise all
the way in.
6.If the water tap is a screw
type,assemble a water
supply hose that fits to
the tap as shown.
Leave some space.
Maintain at least 10cm between the washer
and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise and vibration can occur (allowable slope is 1 degree)
Never install the washer in a very steamy
environment or where it might be open to the rain.
Excessive moisture may cause an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected
by direct heat,never place the washer near furnaces,
boilers,etc.Do not place under direct sunlight.
Check the type of tap fitting which is in your laundry and then see appropriate
instruction below:
ENVIRONMENT
4.Connect the water supply hose to
the adaptor. Pull down the part
(c) of the water supply hose .
When you release part (c) the
hose is automatically connects to
the adaptor making a 'click'
sound.
In case of pump-drained washer
HOW TO CONNECT WATER SUPPLY HOSE
A tap of ordinary type is desirable
In case of square tap
●
Take out the internal part of the connector
and join it in the following way.
ORDINARY TAP SQUARE TAP ROTATING TAP
Internal part
●
Be sure to join tightly
the drain hose into the
drain-outlet on the left
side of the machine.
●
Take out the
cap-hose and
connect the
outlet-hose.
●
Install the drain
hose in the position
of about 70~80cm
above the ground.
cap-hose
outlet-hose
SW65ASP2-00967A-eQuark 7/11/02 3:23 PM Page 4
