HOW TO CLEAN THE FILTER
(In case drain pump)
1. Place a rag under the washer filter
not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and
rotate the filter
clockwise until it
locks in position.
When you open this
lid while the spin basket is
spinning,the spinning will
be stopped by the brake
system.
POWER CORD
EARTH WIRE
WATER DRAIN HOSE
(without pump)
SPIN DRYER BASKET
PULSATOR
CONTROL LEG
The plug’s shape
may not be similar to that
shown in this drawing.
SPIN DRYER LID
(with pump)
WASH TUB LID
Be sure to keep
the lid closed
during washing
and spinning.
WASH TUB
DRAIN FILTER
DRAIN HOSE
OVERFLOW
FILTER
LINT FILTER
INNER LID
DESCRIPTION AND /CLEANING OF PARTS
This is used for
gathering the
dregs made
during washing.
CLEANING THE LINT FILTER
•
If the dregs are piled up in the
lint filter after finishing the wash,
push down and
pull it out as
shown in the
figure.
•
Wash the filter
net in water.
OVERFLOW FILTER
•
Pull the upper side of the
overflow filter with your
fingers into the holes
in the direction of
arrow as shown
in the figure.
OVERFLOW FILTER
Pull the upper side of the
overflow filter with
two fingers inserted into
hole ‘A’ in the
direction of arrow
as shown in the figure.
A
CLEANING THE FILTER
•
Pull the overflow filter out and take up
the filter by removing 3 screws as
shown in figure. Wash the filter and
washing tub.
CLEANING THE FILTER
•
Push the strainer(filter) out and take
up the filter as shown in figure.
Wash the filter and washing tub.
DRAIN FILTER
In case of incomplete drain,
disassemble the drain filter with
screw ), and remove
lints from the filter as shown
in the filter as shown in
the figure.
CLEANING THE WASH TUB
First, fill water in the wash tub to ‘L’ level(
, then drain water from the wash tub simultaneously with
operating wash cycle for 1~2 minutes.
•
Close the wash tub lid.
2
