GB
13
Plug & Auto Set Up
Your VCR will automatically set itself up when it is plugged into the
mains for the first time. TV stations will be stored in memory. The
process takes a few minutes. Your VCR will then be ready for use.
1
Connect the coaxial cable as indicated on page 10.
(Connecting Your VCR to the TV Using the Coaxial Cable)
2
Plug the VCR into the mains. It will automatically tune itself in and
store TV stations in the memory.
3
The process will finish after a few minutes. Then the VCR
automatically switches itself off.
2
12
Connecting Your VCR to the Satellite receiver or Other Equipment
AV2(DECODER/EXT.)
AV1(EURO AV)
R
L
AUDIO
OUT
TV
SCART Cable
SCART Cable
Satellite Receiver or other Equipment
Aerial
TV
AV1(EURO AV)
You can connect your VCR to the Satellite receiver or other VCR using the SCART cable if the appropriate
outputs are available on the equipment chosen. The following illustrations give a few examples of the
connection possibilities.
1
2
AV2(DECODER/EXT.)
AV1(EURO AV)
R
L
AUDIO
OUT
TV
SCART Cable
Satellite Receiver or other Equipment
1. AV1(EURO AV): By means of 21-pin Scart Cable
Plug the SCART Cable with satellite receiver or other equipment into the AV1(EURO AV) socket on the rear of the
VCR.
After making this connection, select the source by pressing the INPUT button for the AV1 input sources.
2. By means of RF Coaxial Cable
After making this connection, you must preset the station received through the satellite tuner.
RF output channel of the satellite receiver should be adjusted away from channel 36, which is used by the VCR,
e.g. re-adjust to channel 33.
AV1(EURO AV)
TV
Aerial
Aerial Connector
1
2
TV
TV
1. AV2 IN: By means of 21-pin Scart Cable
★
(SV-6333X/SV-2333X only)
When the satellite receiver or other equipment is connected to the AV2 socket, AV2 SET must first be
set to EING. (see page 22)
Plug the SCART Cable with satellite receiver or other equipment into the AV2(DECODER/EXT.) socket on the rear
of the VCR.
After making this connection, select the source by pressing the INPUT button for the AV2 input sources.
2. By means of RF Coaxial Cable
After making this connection, you must preset the station received through the satellite tuner.
