Samsung SV-200B, Service Manual

Page: 29 / 72

Alignment and Adjustment
5-4 Samsung Electronics
5-2-2 (b) IF THE NORMAL REMOTE CONTROL
ASS’Y OF X-7/X-8(DX7-R/DX7-RC/
DX8-R/DX8-RC) CHASSIS IS
AVAILABLE
Note 1 :
Two kinds of remote control assÕy are used
for X-7/X-8(DX7-R/DX7-RC/DX8-R/
DX8-RC) chassis.
1. One is a normal remote control assÕy, the other is a
multi remote control assÕy
2. All adjustments are adjusted by normal remote
control assÕy only.
3. For the identification of normal remote control
assÕy and multi remote control assÕy, See page 5-1.
Note 2 : How to use the Ò TEST Ó button.
1. Disattach the inlay of remote control assÕy.
(See Fig. 5-1 and Fig. 5-2)
2. Press the ÒTESTÓ button with the pincers and the
precise driver as shown in Fig. 5-1 and 5-2)
1. When using the Ò INPUT Ó button of remote
control assÕy;
1) Simultaneously press the Ò INPUT Ó button and Ò 1 Ó
button in PB mode.
This will adjust the tracking center automatically.
2) Set the tracking preset using the Ò FINE ( Tracking,
TRK )Ó button of remote control.
3) After adjustment is completed, press the
Ò POWER Ó button to release.
2. When using the Ò TEST Ó button of remote
control assÕy ;
1) Simultaneously press the Ò TEST Ó button and Ò 5 Ó
button in PB mode.
This will adjust the tracking center automatically.
2) Set the tracking preset using the Ò FINE ( Tracking ,
TRK ) button of remote control.
3) After adjustment is completed, press the
Ò POWER Ó button to release.