Samsung SSC-1000, User Manual

Page: 9 / 13

15
User’s Guide
14
%
CAMERA SET
If you want to make a set-up related to
the Samsung Dome Camera, move
CURSOR(
→
) to CAMERA SET in the
main menu, and press the ENTER button.
After this, you can set up while watching
the OSD menu screen in a monitor in
which camera visuals can be displayed.
^ MATRIX SET
If you want to make a set-up related to the
matrix switcher, move CURSOR(
→
) to
MATRIX SET in the main menu, and
press the ENTER button. After this, you
can set up while watching the OSD menu
screen in a monitor in which camera
visuals can be displayed.
& PRESET SET
In order to set up the preset of the
receiver unit (or Samsung Dome Camera),
move CURSOR(
→
) to PRESET SET in the
CAMERA SET MENU, and press the
ENTER button. First, move CURSOR(
→
)
to preset no., press the ENTER button, put
in the number, and press the ENTER
button. Next, move CURSOR(
→
) to
position set, control pan/tilt and the lens,
and press the ENTER button. If you want to
cancel the concerned preset no., move
CURSOR(
→
) to delete, and press the
ENTER button.
If you want to go back to the main menu,
press the MENU button.
$
-1 PASSWORD SETUP
– For password input, move CURSOR(
→
)
to PASSWORD SET, press ENTER,
and put in the 4-digit number.
– For the selection regarding whether to
use a password or not, move
CURSOR(
→
) to disable (or enable),
and press ENTER. Each time you
press a button, enable and disable
change. When you come out of the
set-up mode press the MENU button.
$
-2 BAUD RATE SETUP
Move CURSOR(
→
) to the Baud rate
you want, and press the ENTER button.
∗
38400, 19200, 9600, 4800, 2400, 1200
$ -3 PROTOCOL SETUP
Place the CURSOR (
→
) over a desired
protocol and press the ENTER button.
∗
SAMSUNG, PELCO-D, PELCO-P, VICON
PANASONIC, KALATEL, DIAMOND, AD,
PHILIPS, ERNA, VCL TP, TECHWIN,
HONEYWELL
$ -4 When you set up the controller address,
move CURSOR(
→
) to ADDRESS NO.,
press and ENTER button, put in the
number, and press the ENTER button.
∗
If only one unit is used, set to “0”.
∗
You can not control the currently operating
device in other place, and a message of
"BUSY" appears if you try to do so.
→
PASSWORD SET
ENABLE
→
38400
19200
9600
4800
→
SAMSUNG
PELCO-D
PELCO-P
VICON
M ON = [ 0 0 ] CAM=[ 0 0 0 ]
→
CAMERA MENU
PRESET S ET
D AT A BACK UP
MON = [00] CAM = [000]
∗
CAMERA SETUP
∗
∗
MATRIX SET
∗
MENU KEY: < EXIT >
M ON = [ 0 0 ] CAM=[ 0 0 0 ]
→
PRESET NO [ 0 0 0 ]
POS I T I ON SET
DE L E TE
SSC-1000 (gb) 2009.1.8 1:38 PM Page 14