Samsung SP-C802R, Manual

Page: 22 / 30

41 40
This function allows you to
change the display screen in
the base set standby state
Help Function Help Function
Adjusting the flash time
(In the standby state)
: 0 . 1 sec : 0 . 2 sec : 0 . 3 sec : 0 . 4 sec : 0 . 5 sec
: 0 . 6 sec : 0 . 7 sec : 0 . 8 sec : 0 . 9 sec : 1 . 0 sec
●
The flash time is to 0.4 second as default.
You can adjust the flash
time.
● Even though there was no low voltage warning in the standby state, the low voltage
warning may be generated if you make calls using the remote set as it consumes the
battery.
Low Voltage Warning Function
Charge the remote
set immediagely.
When the battery
charging is insufficient
blinks and warning
tone is transmitted.
This function generates
warning tone when the
battery voltage of the
remote set drops below
the specification.
�
Display Screen Selection
� � � �
� � � �
Press the button
corresponding to the
desired time.
Toll Restriction
1 2 3 4
● When the toll restriction is set, is displayed on the screen and when it is
cancelled, disappears.
●
Even when the toll restriction is set, you can make a toll call with the base set. But,
when you start dialing 8 on the remote set, the unit beeps and then returns to the
standby state.
� Check � Cancel the
toll restriction � Set the toll
restriction
Setting the Dialing Mode
1 2 3 4
● You can set the dialing mode either as rotary dialing or tone dialing.
● When the rotary dialing is set, is displayed during the call and when
the tone dialing is set, is displayed.
� Check � Rotary Dialing � Tone Dialing
● When the dialing mode of the base set is set to the rotary dialing mode
Press button while dialing with the base set or the remote set, and the dialing mode is
switched to the tone dialing mode.
P
T