Samsung SP-C700R, Owner'S Manual

Page: 6 / 22

10 9
Phone Installation
� To turn on the power: Press button (hold for more than 2 seconds) until
you begin to hear the beeping sound.
� If it does not turn on when you press button, then you probably
need to recharge the remote set. It should then automatically turn on.
Please recharge the battery for 24 hours before using it.
� If you do not charge the battery for at least 6 hours, then in order to
protect it, the battery must be fully charged or it will stop operating.
�
To turn off the power: Press buttons (hold for more than 3 seconds) until
you hear the beeping sound.
Connect the phone line.
Connect the power
plug to 220V.
Connect the power
plug to 220V.
DC 12V 500mA
Open the
battery cover. Place the
battery as
shown in the
picture.
Installing the Remote Set
Installing the Base Set
1
2
Rearrange the
line by setting
the battery as
shown in the
picture.
3
Close the
battery cover.
4
Loading the battery to the remote set
Battery life
● The battery life has a 6-month warranty after
purchase.
●
As time goes by, there will be a reduction in the
battery's power. When battery's power capacity is
reduced by half, purchase a new battery and
replace it.
●
Please contact your local Samsung Electronics
Service Center on how to purchase and replace
the battery.
;;
;;
;;
@@
@@
@@
€€
€€
€€
ÀÀ
ÀÀ
ÀÀ
How to use the battery
●
Charge the battery for approximately 24
hours before using.
●
Always remove the battery from the remote
set, when you are not using it for an
extended period.
●
It is best to charge the battery until you see
the ( ) sign on the screen.
To turn on / off the power
� When you have finished installing the base set, press “ On Hook ” button and check for a dial tone.
� If you cannot hear a dial tone, then check both the power and phone line connections.
� This product works for 220V.
� Place the remote set on the charger and check if the lamplight is on.
� Press the call button and check for a dial tone.
� If you cannot hear the tone, check the installation.
DC 12V 500mA
Preparation & Installation