Samsung SMT-190DK, User Manual

Page: 10 / 354

USER'S MANUAL
• Adjust the camera to target the video location
and tighten the bracket handle on the camera
mount bracket. Install the camera on to the
male screw of the Camera Mount Bracket by
rotating the camera in clockwise.
• Loosen the handle by turning it in counter
clockwise direction and then adjust the camera
position. Tighten the handle, turning it clock
wise, and lock the camera in position.
• Connect the camera cable to the camera.
After positioning monitor and installing four cameras to a
desired location, please connect CAMERA to MONITOR
through CAMERA CABLE (MCB-60) as shown in the
below figure. Please check whether or not it is properly
connected.
Connection status checking method :
• Turn on the monitor after connecting cameras,
and check if camera image is displayed.
The initial screen mode of monitor is quad
mode.
• In case monitor and camera is not connected,
OSD ‘L’(LOSS) will be displayed on screen.
2-4) Night Vision Camera
1) Before Installation
SOC-N10 INTRODUCTION
SOC-N10 Night Vision camera is intended to be
used exclusively with those sold by this company
for DIY. With the built-in IR LED and light sensor in
the camera, both day monitoring and night moni-
toring are possible. Also, since it is designed as
weather-proof daily product, it can be used not only
indoors, but also outdoors.
2) Precautions for Installation and Operation
Installing SOC-N10

Make sure the installation location is a place
where it can tolerate 5 times of the total weight
of the camera before installing.

When installing the camera, make sure the
cable is not squeezed in an inappropriate
place or the insulation plastic is removed (it will
be a cause for malfunction or fire).
Handle
Eng-10
USER'S MANUAL