28
Appendix
Light Bulb Replacement
Cooktop Light
Replace the burned-out bulb with a 40-watt incandescent bulb.
1
. To replace the bulb(s), first disconnect the power at the main fuse
or circuit breaker panel or pull the plug.
2
. Remove the screw at the front of the light cover and lower the
cover.
3
. Be sure the bulb(s) to be replaced are cool before removing. After
breaking the adhesive seal, remove the bulb by gently turning. Put
in new bulb.
4
. Replace the light cover and screw. Connect electrical power to the
oven.
������������
���������������������
��������������������
������
���������������
����������������������
Oven Light
1
. Replace the burned-out bulb with a 40-watt incandescent bulb.
To replace the oven light, first disconnect the power at the main
fuse or circuit breaker panel or pull the plug.
2
. Remove the top grille by taking out the 2 screws(on the front of
outer case. See page 29 for the Removing Charcoal Filter) that
hold it in place.
4
. Next, remove the screw located above the door near the center of
the oven that secures the light housing. Remove the housing and
bulb.
4
. Insert new bulb. Replace the light housing and screw.
5
. Replace the top grille and 2 screws, Connect electrical power to
the oven.
������������
���������������������
��������������������
������
���������������
����������������������
Exhaust Feature
The Vent Fan
The exhaust fan has 2 metal reusable grease filter.
A charcoal filter can be used for removing smoke and odors in case the
fan is not vented outside.
������������
���������������������
��������������������
������
���������������
����������������������
Reusable Grease Filters
The metal filters trap grease released by foods on the cooktop. They
also prevent flames from foods on the cooktop from damaging the
inside of the microwave.
For this reason, the filters must ALWAYS be in place when the vent
fan is used. The grease filters should be cleaned once a month, or as
needed.
Removing and Cleaning the Filters
To remove
, slide it to the left using the tab. Pull it down and out.
To clean the grease filters
, soak and then swish them around in hot
water and detergent.
Don’t use ammonia or ammonia products because they will darken the
metal.
Light brushing can be used to remove embedded dirt.
Rinse, shake and let them dry before replacing.
To replace
, slide the filters in the frame slot on the left of the opening.
Pull up and to the right to lock into place.
SMH7175_00356T.indb 28
2006-04-26 ｿﾀﾈﾄ 1:19:13
