16
Step-by-step installation guide
17
Step-by-step installation guide
D. mOUNT THE mICROWAVE
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
ImPORTANT: Do not grip or use the handle
during installation.
NOTE
: If your cabinet is metal, use the nylon
grommet in the power cord hole to prevent the cord
from being cut.
NOTE
: Filler blocks are required when mounting this
unit under any cabinet with a recessed bottom or
front overhang. (See page 9.)
ImPORTANT: The case damage that will occur
from over tightening screws if you do not use
filler blocks is not covered under warranty.
ImPORTANT: For models with the grease filter
installed, don’t push up on the filter when you
mount the oven.
NOTE
: When mounting the microwave oven, thread
the power cord through hole in the bottom of the top
cabinet. Keep it tight throughout Steps 1–3. Do not
pinch the cord or lift the oven by pulling cord.
1
. Lift the microwave, tilt
it forward, and hook
the slots at the back
bottom edge onto the
four lower tabs of the
mounting plate.
2
. Rotate the front of
the oven up against
the cabinet bottom.
3
. Insert a self-aligning screw through the top
center cabinet hole. Temporarily secure the oven
by turning the screw at least
two full turns
after
the threads have engaged. (It will be completely
tightened later.)
B
e sure to keep the power
cord tight. Be careful not to pinch the cord,
especially when mounting flush to the
bottom of cabinet.
Cabinet Front
Filler Block
Microwave Oven Top
Self-Aligning Screw
Equivalent to
Depth of
Cabinet Recess
Cabinet Bottom Shelf
Equivalent
to Depth of
Cabinet Recess
Cabinet Bottom Shelf
Microwave Oven Top
Cabinet Front
Filler Block
Self-Aligning Screw
4
. Attach the microwave oven to the top cabinet.
5
. Insert the 2 self-aligning screws through the
cabinet bottom shelf and filler block into the
outer top cabinet of the unit. Continue to
support the unit until both screws are inserted
and engaged at least two full turns, then fully
tighten both screws until the unit is secure.
6
. Install the grease filters. See the Owner’s Manual
packed with the microwave for instructions.
NOTE
: For models with installed grease filters, you
do not need to install a filter.
E. CONNECTING DUCTWORK
FOR OUTSIDE TOP
EXHAUST
House Duct
House Duct
1
. Extend the house duct down to connect to the
exhaust adaptor.
2
. Seal the exhaust duct joints using duct tape.
SMH1927_XAA_DE68-04108A-01_EN_120725.indd 17
2012-07-25 �� 7:54:37
