Samsung SL10D10, User Manual, Page: 69 / 87

Remote Control Problems
Problems with the remote control

Check that nothing is between the remote control and the remote sensor.

Make sure the remote control is in DIRECTV mode. Slide the mode switch to the DIRECTV
position so the remote will control the Samsung FlipTop powered by DIRECTV
®
.

Check the batteries in the remote control. They may be weak, dead or installed incorrectly. Try
replacing batteries.

If you’re entering a channel number that is less than four digits long, the receiver might wait
two seconds before tuning to the channel. Press ENTER after entering a channel number to
tune immediately.

If you are trying to operate a device other than the Samsung FlipTop powered by DIRECTV
®
that you have programmed the remote to control, make sure you first slide the input switch to
the corresponding device (AV). The indicator light for the component you’re trying to control
should light up when you press a valid key for that component. If it doesn’t, make sure the
input switch is clicked into the correct position.
A remote control indicator light starts flashing.
The batteries in the remote control are running low and should be replaced soon. (Note that when you
replace the batteries, you may have to reprogram your remote to control other devices.)
Troubleshooting
Chapter 5
61