Alignment & Troubleshooting
Service Manual
4-13
Samsung Electronics
4.1.5.3 Data Setup
SEND LEVEL
You can set the level of the transmission signal. Typically, the Tx level should be under -12 dBm.
&DXWLRQ7KH6HQG)D[/HYHOLVVHWDWWKHEHVWFRQGLWLRQLQWKHVKLSPHQWIURPIDFWRU\1HYHUFKDQJHVHWWLQJV
arbitrarily.
DIAL MODE
This function can choose dial method.
*Default : Dial(Dial/Pulse)
MODEM SPEED
You can set the maximum modem speed.
Communication is done with modem speed automatically set at lower speed when communicating with a
slower speed modem since communication is done on the standard of the side where modem speed is low
for transmission/reception. It is best set 33.6Kbps as default setting.
ERROR RATE
:KHQWKHHUURUUDWHLVDERXWH[FHHGWKHVHWYDOXHWKH%DXGUDWHDXWRPDWLFDOO\DGMXVWVWRESV
This ensures that the error rate remains below the set value.
You can select the rate between 5% and 10%.
CLEAR ALL MEMORY
The function resets the system to factory default settings.
This function is used to reset the system to the initial value when the product is functioning abnormally. All the
values are returned to the default values, and all the information, which was set by the user, will be erased.
< Method >
6HOHFWWKH>0(025<&/($5@DWWKH7(&+02'(
2. Push the OK button.
3. Select you country. (There are four country groups. Refer to the table below.)
4. Push the OK button then it will clear all memory.
NOTICE : Always perform a memory clear after replacing the main board. Otherwise, the system may not
operate properly.
Country Group
USA/Canada
UK
Russia
Southafrica
Country
USA/Canada
Mexico
Brazil
UK
Germany
France
Italy
Spain
Austria
Netherlands
Belgium
Portugal
Sweden
Norway
Denmark
Finland
Switzerland
Greece
Ireland
Turkey
Russia
India
Oman
Poland
Bangladesh
Kuwait
Moroco
Algeria
Pakistan
UAE
Bahrain
Srilanka
Saudi Arabia
Chile
Peru
Argentina
+XQJDU\
Romania
Bulgaria
Czech
South Africa
