COLOR DOME CAMERA
User Guide
12
COLOR DOME CAMERA
User Guide
13
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Base moves by 176° to each side direction and 352° on the whole.
• Tilt Base covers 75˚ angle.
• Rotate Base moves by 174° to each side direction and 348° on the whole.
2) Methods of adjustment
•
The case of wall installation
…
1
After mounting the camera on a wall, adjusting the panning angle so that the camera can
face the direction to monitor when tilted.
…
2
Adjust the tilting angle by rotating the tilt base.
…
3
Loosen the rotate base hold screw and adjust rotate base for the best view.
…
4
Tighten the rotate base hold screw.
•
The case of ceiling installation
…
1
After mounting the camera on a ceiling, adjusting the panning angle to the correct viewing
position by rotating the pan base.
…
2
Adjust the tilting angle by rotating the tilt base.
…
3
Loosen the rotate base hold screw and adjust rotate base for the best view.
…
4
Tighten the rotate base hold screw.
Adjust the panning and tilting, rotating while watching the monitor
Installation
Connect the Video Output jack to the VIDEO-IN jack of monitor.
• As the connecting method varies with the instruments, refer to the manual supplied with the
instrument.
• Only connect the cable when the power is turned off.
Connect the adaptor to the power input connector as shown in the figure below. The
recommended adaptor specification for SCD-2020N/P, SCD-2040N/P, SCD-2021N/P is AC 24V /
300mA or DC 12V / 500mA.
Connection
Connecting to Monitor
Connecting to Power
75˚
176˚
174˚
174˚
176˚
Pan Base
Tilt Base
Rotate Base
CCTV Camera
Monitor
---- Power Input Terminal
3) Please change the EFL in LENS SAHDE menu after changing the lens, so that the function
operates properly.
When the resistance value of copper wire is at [20°C(68°F)]
Copper wire size (AWG)
#24(0.22mm
2
)
#22(0.33mm
2
)
#20(0.52mm
2
)
#18(0.83mm
2
)
Resistance (Ω/m)
0.078
0.050
0.030
0.018
Voltage Drop (V/m)
0.028
0.018
0.011
0.006
• As shown in the table above, voltage decreases as the wire gets longer. Therefore
use of an excessively long adaptor output line for connection to the camera may
affect the performance of the camera.
*Standard voltage for camera operation : AC 24V ±10% / DC 12V ±10%
*There may be some deviation in voltage drop depending on the type of wire and the manufacturer.
