English
_15
●
in
St
aLL
ation & connection
connectinG witH otHer Device
connecting to the monitor
Connect the video out port of the camera to the video input port of the monitor.
`
To check the display screen after installing the camera for the first time, you can use the Video
port to check the video screen.
`
You can set the video output type to either NTSC or PAL. (page 29).
`
The Video source (4:3) will be displayed with either side truncated in comparison with the
HD-SDI video.
`
The video source from the HD-SDI port can be displayed on the dedicated monitor. To display the
source on a commercial monitor, you need a converter to convert the video signal as appropriate.
video cable
The cable connecting the camera’s video output and a monitor is a BNC coaxial cable as
shown below.
If the distance between the camera and the monitor exceeds the recommended maximum,
please us an auxiliary video amp.
Maximum video transfer
distance
Recommended cable
specification
100~140m
5C2V(75ohm)
200m
L-6CHD(75ohm)
(SDI-specific Cable)
PT01-000568B-SCB-6000-ENGLISH-.indb 15
2011-07-05 오후 2:33:14
HD-SDI
VIDEO
POWER
HD-SDI
HD-SDI Monitor
Test monitor for
installation
Motion detection output device
J
3 : MD_OUT
1 : GND
4 :
2 : EXT_D/N
5 : RS_485-
Day/Night mode
controller
