operating
_13
02
OPERA
TING
( 6 )
Ice Off
(hold 3 sec for child
lock)
If you don’t want to make more ice,
touch this button. Also, pressing and
holding this button for 3 second
locks the display panel and dispenser
buttons so the buttons can not be
used. The Child Lock icon lights up
to indicate you’ve activated the Child
Lock function.
(7)
Ice Type
Touch this button to select your
desired ice type. Cubed and crushed
ice modes alternate each time you
press the Ice Type button.
Note that when you push the Ice
Type button, you turn the Water
dispenser off.
(8)
Water
Touch this button to dispense water.
Note that you cannot dispense water
and ice simultaneously.
The Water dispenser turns off when
you press the Ice Type button.
cooling Off
Mode
Cooling Off mode (also called Shop
mode), is designed for use by
retailers when they are displaying
refrigerators on the shop floor. In
Cooling Off mode, the refrigerator's
fan motor and lights work normally,
but the compressors do not run, and
the refrigerator and freezer do not
get cold.
To start Cooling Off mode, Touch
and hold the Energy Saver button
and the Power Freeze button for 5
seconds during normal operation.
The refrigerator chime sounds and
the temperature display flashes OF
OF.
To cancel Cooling Off mode, Touch
and hold the Energy Saver and the
Power Freeze buttons again for 5
seconds.
( 9 )
Ice Off
When you touch the Ice Off button
( ), the Ice Off icon lights and the
Ice Maker stops making ice.
We recommend you stop ice
making if the following occur:
-
There is enough ice in the ice
bucket.
-
You want to save water and
energy.
-
Water is not being supplied to the
refrigerator.
If the ice maker function is
ON, and the water line is not
connected, there will be a water
valve noise from back of the
unit. Press the Ice Off (Hold
3sec for child lock) button (
) for less than 3 seconds
until the Ice Off Indicator ( )
illuminates.
If you do not touch any button, the freezer and fridge
temperature indicator turn off in a few seconds.
If you touch any button, the display lights up again.
( 10 )
Filter
Water filter usage
The Water Filter icon lights in red
when you need to change the water
filter.
This occurs after you use about 300
gallons of water (which usually takes
about 6 months).
After install the new water filter, reset
the Water Filter icon by touching the
Alarm/Hold 3 sec for Filter Reset
button for 3 seconds.
•
If water is not dispensing or
dispensing slowly, you need to
replace the water filter because
the water filter is clogged.
•
Some areas have large amounts of
lime in theirwater which causes the
water filter to clog more quickly.
DA68-02500A.indb 13
2011.3.7 9:1:11 AM
