setting up
_11
01
SETTING
u
P
check the amount of water supplied to the ice
tray.
1.
Lift up the icemaker cover and gently pull it out.
2.
When you press the Test button for 3 seconds,
the ice cube container is filled with water from the
water supply tap. Check to make sure the amount
of water is correct (see the illustration below). If the
water level is too low, the ice cubes will be small.
This is a water pressure problem from within the
main water pipes, not the refrigerator.
-
It will take a few minutes for the water to
reach the correct level after you push the
Test button.
-
Do not press the test button continuously when
the tray is filled with ice or water. Water may
overflow or ice jamming may occur.
-
When the bucket is not installed, the ice maker
does not work.
-
When Ice Off blinks on the display panel, reinsert
the bucket and/or make sure it’s installed properly.
Ice maker
1
Test button
check the water
level
2
cAuTION
DA68-02500A.indb 11
2011.3.7 9:1:9 AM
