Samsung RF263BEAE SERIES, User Manual

Page: 13 / 56

setting up _13
01
SETTING UP
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a fi lter is one of the helpful
features on your new refrigerator. To help promote
better health, the water fi lter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a
water pressure of 138~862 kPa is required.
Under normal conditions, a 0.17 L cup can be
fi lled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure, you can install a booster pump to
compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly fi lled. To do this, press the water dispenser
lever until the water runs from the water outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and compression nut.
Connecting to the water supply line
First, shut off the main water 1.
supply.
Locate the nearest cold water drinking line and 2.
install the pipe clamp and shut off valve.
Connect the water line installation kit to the 3.
shut off valve.
Connecting the water supply line to
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may fi nd these items sold as a kit at your local
hardware store.
Use Copper Tubing Use Plastic Tubing
copper tubing •
compression nut (1pc) •
Ferrule (2pc) •
plastic tubing •
→
Molded end(Bulb)
compression nut (1pc) •
Pipe clamp
Cold water line
Shut off valve
Shut off valve
Pipe clamp
Cold water line
Water line installation kit
DA68-02615A(0.0).indb 13 2012.7.11 8:41:19 PM
1. Pull out the freezer drawer ,then you can
see the lower hinge .
2.
3. Adjust the height by turning a philips
screwdriver (+) clockwise ( ) or
counterclockwise ( ).
1
2
3
4
Insert a philips screwdriver (+) into the shaft
of the lower hinge.
DOWN
UP
3
1
2
3
4
3
When you turn a philips screwdriver (+)
counterclockwise ( ), the door will
move up.
UP