operating
_21
02
OPERA
TING
Reverse Osmosis Water Supply
IMPORTANT :
The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 35
and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa.) If
the water pressure to the reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
• Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace
the filter if necessary.
• Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
• If your refrigerator has a water filter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure,
call a licensed, qualified plumber.
USING THE COLD WATER
DISPENSER
Using the Water dispenser (RF221**)
Place a glass underneath
the water outlet and push
gently against the water
dispenser lever with your
glass. Make sure the
glass is in line with the
dispenser to prevent the
water from splashing out.
PUSH
If you have just installed the refrigerator or installed
a new water filter, Flush 11 L through filter before
use (flush approximately 6 minutes). Make sure
water flows cleanly before drinking.
If you have a long vacation or business
trip, close the water valve and shut off
the water supply to the Refrigerator. This
will help prevent accidental leakages.
•
Water clouding phenomenon
• All water provided to refrigerators flows
through the core filter which is an
alkaline water filter. In this process, the
pressure in the water that has flowed
out of the filter gets increased, and
oxygen and nitrogen become saturated.
When this water flows out in the air, the
pressure plummets and the oxygen and
nitrogen get supersaturated so that they
turn into gas bubbles. The water could
look misty due to these oxygen bubbles.
The water may look temporarily cloudy
due to these oxygen bubbles. After a
few seconds, the water will look clear.
• The water tank’s capacity is
approximately 1 L.
• Please wait 1 second before removing
the cup after dispensing water to
prevent spills.
CAUTION
DA68-02657A-12.indb 21
2018. 10. 8. 오후 5:46
