Samsung PS42C6HX/XEC, Service Manual

Page: 75 / 116

Circuit Description
Samsung Electronics 13-7
■
Requisite Components Necessary for Drive Board Operation
1) Power
- Supplied from the power board. The optimal value may differ from the following:
a) Vs : 200V - Sustain
b) Vset : 190V - Y Rising Ramp
c) Ve
: 110V - Ve bias
d) Vscan : -190V - Scan low bias
e) Vsc_h : -70V - Scan high bias (Created by the DC-DC power block of the Y Drive board)
f) Vdd
: 5V - Logic signal buffer IC
g) Vcc : 15V - Gate drive IC
2) Logic Signal
- Supplied by the Logic board
- Gate signal of each switch
■
Drive Circuit Architecture and Function Description
- Description of the function of each board
Y Pole Terminal
(6 Block)
X Pole Terminal
(2 Block)
Power B'd
Logic B'd
Logic E-Buffer
Logic F-Buffer
- Sustain Pulse
(Energy Recovery)
- Rising Ramp Pulse
- Falling Ramp Pulse
- Vscan Pulse
Y-Buffer
Y Drive B'd
X Drive B'd
- Sustain Pulse
(Energy Recovery)
- Ve Bias
1) X Drive Board
This is connected to the X port part of the panel. 1) Sustain voltage waveform (including ERC) is output, and 2) Ve bias in the Scan
section is maintained.
2) Y Drive Board
This is connected to the Y port part of the panel. It outputs 1) Sustain voltage wave form (including ERC), and 2) Y Rising, Falling
Ramp waveform, and maintains 3) Vscan bias.
3) Y Buffer Board
A board, which applies the Scan waveform to the Y terminal block, consists of 12 Scan Driver ICs (TI SN755870: 64 Outputs).