Samsung POWERbot VR2AR7260W, Manual

Page: 31 / 108

ENGLISH- 31
Troubleshooting
Symptom Checklist
The POWERbot is not working at all.
f Check if the emergency switch is on.
f
Check if all the icons are displayed on the display panel.
f
Check if the POWERbot's battery is depleted.
– When "Lo" is displayed, place the POWERbot on the
docking station to charge it.
f
Replace the batteries (AAA type) if the remote controller is
not working.
The POWERbot has stopped during
cleaning.
f
When "Lo" is displayed on the display panel, place the
POWERbot on the docking station to charge it.
f
When POWERbot is immobilized by an obstacle such as a
cord, threshold etc, pick it up and move it away from the
obstacle.
– If any fabric or string is caught in a drive wheel, turn off
the emergency switch and remove the fabric or string
before using it again.
Suction power is weak.
f When there's too much dust in the dustbin, suction power
may get weakened. Turn off the emergency switch and
empty the dustbin.
f If the brush is blocked by foreign matter, turn off the
emergency switch and remove foreign matter from the
brush.
f
When noise suddenly increase, turn off the emergency
switch and empty the dustbin.
The POWERbot cannot find the
docking station.
f Check if there's a power failure or whether the power plug
is unplugged.
f Remove any obstacles around the docking station that may
prevent POWERbot from returning to the docking station.
f When there's foreign matter on the charging pins, charging
can be affected. Clean the foreign matter off the pins.
The POWERbot suddenly cleans
diagonally.
f
Check if the docking station is installed along the grain of
wooden floors or tiles.
f The POWERbot may clean in a diagonal direction if it is
moving to another area using the shortest route. It may also
move at a diagonal if it made contact with an obstacles at
that angle, if it was charged at the docking station at an
angle, or if the grain of the wooden/tile floor skewed is in
that direction.
POWERbot does not detect the
boundary marker and crosses the
boundary.
f
Make sure the boundary markers are attached as ( )
shape at 15 cm before the locations where the POWERbot
shouldn't cross.
1_VR7200_EN_DJ68-00827B-00_AA.indd 31 2019-03-19 오후 5:25:54