18
Q
<Wake On LAN> function
A1
<Wake On LAN> is a function that activates
the system in rest mode when a signal (such
as ping or magic packet commands) arrives
from network (wired LAN).
To use <Wake On LAN> function:
Select
My Network Places > View network
connections
from the Desktop.
Click the right button on the touchpad over
Local Area Connection
, and select
Properties
.
Click
Configure
, and select
Power
Management
tab. Select “Allow this device to
bring the computer out of standby”, then click
OK
. Restart the system.
– When turning the computer off when the network is
connected without selecting the
<Wake On LAN>
function, the
LAN LED
may not be turned off.
– The
<Wake On LAN>
function is only available
when the LAN is turned on.
– When connecting a wired LAN while using a
wireless LAN, the
<Wake On LAN>
function may
not work. To use the
<Wake On LAN>
function,
select “Do not use Wireless LAN.”
– Connecting wired LAN while using wireless LAN
may not execute
<Wake On LAN>
function.
Configure wireless LAN to “Disable” to use
<Wake
On LAN>
function.
Click
My Network Place> View network
connections
on the Desktop.
Right-click over
Wireless Network Connection
and select
Disable
.
A2
The <Wake On LAN> function is configured so that
it is supported in
Standby
mode (S3). To use this
function in
Hibernation
mode (S4) or in the Turn Off
(S5) state, configure it as follows:
Enter
BIOS SETUP
and select the
Boot
menu.
Move to the
Wake On Lan
item and press the
Enter
key. Change it from
Disabled to Enabled
and press the
Enter
key.
Q
When I connected 100Mbps wired LAN and
the computer exits standby/hibernate mode,
a message informing 10Mbps wired LAN
connection appears.
A
When the computer exits standby/hibernate mode,
restoring the network takes about 3 seconds. When
the network is restored, it operates in 100Mbps.
Wired LAN Related
Summary of Contents for P200
Page 1: ...User Guide Q45c Q46c P200 ...