English 21
Ins
tallation ins
truc
tions
Step 3. Convert to lp gas (optional)
All new gas ranges are shipped from the factory set up to use natural gas. Any
Samsung gas range can be converted to use LP gas. Refer to page 55 in the User
Manual to contact a qualified service technician.
The conversion process should only be performed by a qualified LP gas installer.
Conversion instructions and LP orifices will be supplied with the LP conversion kit.
The conversion to LP requires all burner orifices to be changed (5 surface burners
and 2 oven burners).
In addition, the nozzle on the gas pressure regulator needs to be reversed. All
replaced orifices must be left with the consumer, including the instructions and
retrofit sizes and orifice indication.
Checking the flame quality all burner after converting to lp gas.
Step 4. Install the anti-tip device
WARNING
To reduce the risk of tipping, the appliance must be secured by properly installing
the anti-tip device packed with the appliance.
•
All ranges can tip, resulting in personal injury.
•
Tipping ranges can cause burns from spills, personal injury, and/or death.
•
To prevent accidental tipping, install and check the anti-tip bracket following the
instructions and template supplied with the bracket.
An anti-tip bracket and screws, installation
instructions, and template are shipped
with every range (PN DG94-00870B). The
instructions include information necessary
to complete the installation of the anti-tip
bracket. Read and follow the instructions on
the sheet and use the template for anti-tip
bracket installation. If not properly installed,
the range could be tipped by you or a child
standing, sitting, or leaning on an open oven
door.
*approximately
21
/
32
” (16.5 mm)
Screw must enter
wood or concrete
Anti-Tip
bracket
*NOTE:
To install the Anti-Tip
bracket, release the leveling
leg. A minimum clearance of
21
/
32
” (16.5 mm) is required
between the range bottom
and the kitchen floor.
To check if the bracket is installed and engaged properly, remove storage drawer
and look underneath the range to see that the leveling leg is engaged in the
bracket. Carefully tip the range forward. The bracket should stop the range within
4 inches (10.2 cm) of tipping. If it does not, the bracket must be reinstalled.
01. DG68-01600A-00_IM_NSG6DG8700SRAA_EN_231102.indd 21
01. DG68-01600A-00_IM_NSG6DG8700SRAA_EN_231102.indd 21
2023-11-06 오전 11:47:49
2023-11-06 오전 11:47:49
