Installing a 4-wire conduit
• Aluminum building wire may be used but it must be rated for the correct amperage
and voltage to make the connection. Connect the wires as described below.
• The wire you use, the location and enclosure of splices, etc., must conform to good
wiring practices and local codes.
1
. Loosen the 3 lower terminal screws from the terminal block. Remove the
ground screw and ground plate and retain them.
2
.
Cut and discard the ground strap. Do not discard any screws.
3
. Insert the ground bare wire tip between the range frame and the ground
plate (removed earlier) and secure it in place with the ground screw (removed
earlier).
4
. Insert the bare wire (white/neutral) tip through the bottom center of the terminal
block opening.
5
. Insert the two side bare wire tips into the lower left and the lower right terminal
block openings.
6
. Tighten the screws until the wire is firmly secured (35 to 50 inch-lbs.). Do not
over-tighten the screws since it could damage the wires.
7
. Go to
Step 5
on page 15 to continue with the installation.
Ground strap
Ground plate
White
Black
Red
Neutral
terminal
Ground
wire
(Green)
Wire tips
White
Black
Red
English - 14
Install_NE58H9970WS_AA_AC_DG68-00594A-05_EN+MES+CFR.indb 14
2017-08-11 6:28:43
Summary of Contents for NE58K9850WG
Page 19: ...memo Install_NE58H9970WS_AA_AC_DG68 00594A 05_EN MES CFR indb 19 2017 08 11 6 28 44 ...
Page 39: ...notas Install_NE58H9970WS_AA_AC_DG68 00594A 05_EN MES CFR indb 19 2017 08 11 6 28 49 ...
Page 59: ...notes Install_NE58H9970WS_AA_AC_DG68 00594A 05_EN MES CFR indb 19 2017 08 11 6 28 53 ...
