Samsung NA24T4230FS, Installation Manual

Page: 23 / 84

23 English
Installation instructions
Installation instructions
Required tools
Adjustable wrench
1
/
2
” open-end wrench Screwdrivers: Phillips
Small flat-bladed
precision screwdriver
Nut drivers:
9
/
32
” or
7 mm
To convert your cooktop for use with LP gas, perform the following steps and procedures:
1. Disconnect electrical power to the cooktop. Unplug the cooktop power cord, trip
the circuit breaker, or remove the fuse from the fuse box.
2. Shut off the gas supply to the cooktop. Close the manual shut-off valve to the
cooktop.
NOTE
If you are using L P gas to fuel the cooktop, the following steps and conversions
must be made before the flames can be adjusted.
1. Using adjustable wrench , turn the cap. And carefully look at the spring retainer
to locate the NAT or LP position.
Cap
gas setting nut
L.P./Propane
NAT
LP
Position
NAT. Position
Pressure Regulator
2.
The pressure regulator valve is set to N AT display by default when it leaves the
factory. Use your fingers to unscrew the gas setting nut , then turn it over to the
position of the LP display, install it on the cap with your fingers, and tighten it.
3. Screw the cap back onto the regulator and tighten.
Install_NA30R5310FG_AA_DG68-01133A-00_EN.indd 24 2019-04-12 12:13:38
Converting the pressure regulator