10
Step-by-step installation guide
D. ALIGNING THE WALL PLATE
CL
CAUTION:
Wear gloves to avoid cutting
fingers on sharp edges.
Area E
Hole B
Hole A
Centerline
notches
Draw a Vertical Line
on Wall from Center
of Top Cabinet
Draw a Horizontal line on wall from
bottom of “Rear Wall Template”.
Horizontal Line
Horizontal Line
Draw a Horizontal line on wall from bottom of “Rear
Wall Template”.
Draw a Horizontal line on
the wall along the bottom
of “Rear Wall Template”.
Horizontal Line
Horizontal Line
Area E
Centerline
notches
Hole A
Hole B
CAUTION
: Wear gloves to avoid cutting fingers
on sharp edges.
1
. Draw a Horizontal line on the wall at the
bottom of the “Rear Wall Template”.
2
. Drill ⅝˝ holes for toggle bolts in 3 locations
(Hole A, Hole B, Hole C) as shown in the
illustration above. If the location of a hole
lines up with a stud, drill a
3
/
16
˝ hole for a
wood screw. You cannot use a toggle bolt to
attach the wall plate to a stud.
NOTE: DO NOT MOUNT THE PLATE AT
THIS TIME.
3
. Holes A, B and C are inside area E. If none
of these holes line up with a stud, find a stud
in area E that lines up with a hole circle in
Area E, and then drill a
3
/
16
˝ hole into it for
a wood screw. You must have at least one
wood screw mounted firmly into a stud to
support the weight of the microwave.
Set
the mounting plate aside.
Manual-Installation_MC17J8100CS_AC_DE68-04129B-02_EN+CFR.indb 10
2017-11-02 2:47:02
