Samsung LN-T1953H, Owners Instrucitons

Page: 8 / 89

English - 6
1. Lift the cover at the back of the remote control upward as shown in the figure.
2. Install two AAA size batteries.
Make sure to match the "+" and "–" ends of the batteries with the diagram inside the compartment.
3. Replace the cover.
Remove the batteries and store them in a cool, dry place if you won’t be using the remote control for a
long time.
The remote control can be used up to about 23 feet from the TV.
(Assuming typical TV usage, the batteries should last for about one year.)
If the remote control doesn’t work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
Installing Batteries in the Remote Control
Connecting VHF and UHF Antennas
ANT 2 IN
(CABLE)
ANT 1 IN
(AIR)
UHF
VHF
ANT 1 IN
(AIR)
UHF
VHF
Connections
If your antenna has a set of leads that look like the diagram to the right, see "Antennas with 300
Ÿ)ODW7ZLQ/HDGVEHORZ
I I\RXUDQWHQQDKDVRQHOHDGWKDWORRNVOLNHGLDJUDPWRWKHULJKWVHH$QWHQQDVZLWKŸ5RXQG
Leads".
If you have two antennas, see "Separate VHF and UHF Antennas".
1.
3ODFHWKHZLUHVIURPWKHWZLQOHDGVXQGHUWKHVFUHZVRQDŸDGDSWHU
(not supplied).
Use a screwdriver to tighten the screws.
2. Plug the adaptor into the ANT 2 IN (CABLE) terminal on the back of the TV.
$QWHQQDVZLWKŸ)ODW7ZLQ/HDGV
,I\RXDUHXVLQJDQRIIDLUDQWHQQDVXFKDVDURRIDQWHQQDRUUDEELWHDUVWKDWKDVŸWZLQÀDWOHDGVIROORZWKHGLUHFWLRQV
below.
1. Plug the antenna lead into the ANT 1 IN (AIR) terminal on the back of the TV.
$QWHQQDVZLWKŸ5RXQG/HDGV
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before con-
necting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics shops).
1. Connect both antenna leads to the combiner.
2. Plug the combiner into the ANT 1 IN (AIR) terminal on the bottom of the rear panel.