Samsung LN-S1951W, Owner'S Instructions Manual

Page: 14 / 80

English-12
Viewing the Display
Press the button once more or wait approximately 10 seconds and it disappears automatically.
Press the INFO button on the remote control to view current channel and the status of certain
audio-video settings.
Adjusting the Volume
1. Press the VOL or VOL button to increase or decrease the volume.
Using MUTE button:
At any time, you can temporarily cut off the sound using the MUTE button.
1. Press the MUTE button and the sound cuts off. The word “Mute” will appear in the lower-left corner
of the screen.
2. To turn mute off, press the MUTE button again, or simply press the VOL or VOL button.
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal
source that is connected to the TV (i.e. an antenna or a cable system).
1. Press the MENU button to display the menu.
Press the or button to select “Channel”, then press the ENTER button.
2. Press the ENTER button to select “Air/Cable”.
3. Press the or button to select the video signal source,
then press the ENTER button.
4. Press the EXIT button to exit.
STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system that exists in your particular area.
At this point, the signal source has been selected.
Proceed to “Storing Channels Automatically”. (See page 13)
Changing Channels
Using the Channel Buttons:
1. Press the CH or CH button to change channels.
When you press the
CH or CH
button, the TV changes channels in sequence.
You will see all the channels that the TV has memorized.
(The TV must have memorized at least three channels).
You will not see channels that were either erased or not memorized.
Using the PRE-CH Button to select the Previous Channel:
1. Press the PRE-CH button. The TV will switch to the last channel viewed.
To quickly switch between two channels that are far apart, tune to one channel, then use the number
button to select the second channel. Then use the PRE-CH button to quickly alternate between them.
Air 3
Mono
Picture
: Dynamic
Sound : Custom
MTS : Stereo
12:00 am
Enter Move Return
Air/Cable
Air
STD
HRC
IRC
Enter Move Return
Channel
Air/Cable : Air
Auto Program
Add/Delete
Fine Tune
BN68-00998F-00Eng.qxd 4/21/04 6:51 PM Page 12