ENG - 15
LED
Status
Description
Resolution
Red and blue
Blinking
Malfunction
See the contact information for the Samsung Service
Centre in this manual.
NOTE
• If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the STANDBY LED on the rear of the sub-woofer will
turn red after blinking in blue several times.
• If you use a device that uses the same frequency as the Soundbar near the Soundbar, interference may cause some sound interruption.
• The maximum transmission distance of the main unit’s wireless signal is about 10 m, but may vary depending on your operating environment.
If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all because the
wireless signal cannot penetrate metal.
CAUTION
• Wireless receiving antennas are built into the wireless subwoofer. Keep the unit away from water and moisture.
• For optimal listening performance, make sure that the area around the wireless subwoofer and the Wireless Receiver Module (sold separately)
is clear of any obstructions.
Auto EQ
Samsung’s
Auto EQ
Technology uses a microphone mounted in the subwoofer to detect and correct low-frequency response peaks caused by the
room dimensions and the subwoofer location. The result will be a more neutral overall low-frequency response.
• Subwoofer should be placed with a
minimum of 3” (8 cm) clearance
from each side to the nearest boundary.
• You must keep the room as quiet as possible while operating the
Auto EQ
tuning.
• Do not use any buttons until the
Auto EQ
tuning is complete.
•
Auto EQ
tuning takes about 2 minutes.
• During
Auto EQ
tuning, there is no sound from the Soundbar’s main unit and rear speakers.
If you are using the function for the first time
1.
Press the
(Sound Control)
button until
Auto EQ
is selected.
2.
Press the
Up
/
Down
buttons to select
Tuning
, and then press the button.
3.
Tuning will start, and the progress appears in percentage.
‒ To cancel tuning, press the
Up
,
Down
,
Left
,
Right
or button, and then press the button to confirm.
‒ If the tuning is failed, LED blinks in red.
‒ If the tuning is successful, LED blinks in blue.
If you have done the tuning process
1.
Press the
(Sound Control)
button until
Auto EQ
is selected.
2.
Press the
Up
/
Down
buttons to select
Tuning
, and then press the button.
3.
Press the
Up
/
Down
buttons to select one of the following options.
‒
On
: Turn on the previously tuned EQ settings.
‒
Off
: Turn on the default EQ settings.
‒
Tuning
: Start the tuning process again.
Connecting an SWA-9500S (Sold Separately) to your Soundbar
Expand to true wireless surround sound by connecting the Samsung Wireless Rear Speaker Kit (SWA-9500S, sold separately) to your Soundbar.
For detailed information on connections, see the Samsung Wireless Rear Speaker Kit manual.
